16
• When auto mode is selected, the air conditioner begins operating
automatically according to factory settings. The temperature cannot
be adjusted, and will not be displayed. Press the “FAN” button to
adjust fan speed, and the “SWING” button to adjust the angle of the
louver.
• When cool mode is selected, the air conditioner begins operating in
cool mode. The cool indicator will be present in indoor units in the
ON status (This indicator is not available on some models). Press the
“▲“ or “▼“ button to set the temperature. Press the “FAN” button to
adjust fan speed, and the “SWING” button to adjust the angle of the
louver.
• When dry mode is selected, the air conditioner begins operating
at low speed under dry mode. The dry indicator will be present in
indoor units in the ON status (This indicator is not available on some
models). The fan speed cannot be adjusted in dry mode. Press the
“SWING” button to adjust the angle of the louver.
• When the fan mode is selected, the air conditioner begins operating
in fan only mode, without cooling or heating. Press the “FAN” button
to adjust fan speed, and the “SWING” button to adjust the angle of
the louver.
• When the heat mode is selected, the air conditioner will begin
operating in heat mode. The heat indicator will be present in indoor
units in the ON status (This indicator is not available on some
models). Press the “▲” or “▼“ button to set the temperature. Press
the “FAN” button to adjust fan speed, and the “SWING” button to
adjust the angle of the louver. (Cooling only units don’t have heat
mode. To set the heat mode with the remote control, press the ON/
OFF button if you cannot start the unit).
Note:
• To avoid circulating cold air throughout the room, the indoor unit will
only begin circulating air 1~5 minutes after heat mode is activated
(actual delay time will depend on the indoor ambient temperature).
• Temperature range that can be set with the remote control: 16~30 °C;
Fan speed: auto, low speed, medium speed, high speed.