Whirlpool AKR 931 AL-1 Program Chart

Marca: Whirlpool

Modelo: AKR 931 AL-1

Categoria: Exaustores

Tipo: Program Chart



AKR 931

5019 100 75182/A

INSTALLATIONSANGABEN

Mindestabstand zur Kochfläche: 65 cm (Elektroplatten), 75 cm (Gas-, Öl-,

Kohlekochmulde). Folgen Sie bei der Installation der Nummerierung (1

.....). Das

Auslassrohr und die Befestigungsmanschetten (18) werden nicht mitgeliefert und

müssen gesondert erworben werden. Das Gerät darf erst nach erfolgter Installation an die

Stromversorgung angeschlossen werden. Der Stecker der Dunstabzugshaube muss mit

einer normgerechten und gut zugänglichen Steckdose verbunden werden. Wenn die

Dunstabzugshaube nicht mit einem Stecker versehen ist (direkter Netzanschluss), muss

ein zweipoliger, normgerechter, gut zugänglicher Schalter eingebaut werden, dessen

Kontakte einen Abstand von mindestens 3 mm aufweisen). Prüfen Sie den

Stromanschluss der Beleuchtung und des Motors (17).

INSTALLATION SHEET

Minimum height above cooker: 65 cm (electric cookers), 75 cm (gas, gas oil or coal

cookers). To install follow points (1

.....). The exhaust pipe and fixing tabs (18) are

not provided and should be bought separately. Do not connect the appliance to the

electrical power supply until installation is completed. The power plug of the hood must

be connected to a socket that complies with current regulations, located in an easily

accessible point. If the hood is not fitted with a plug (direct connection to the power

supply), fit a two-pole switch in compliance with regulations, with minimum break

distance between contacts of 3 mm (easily accessible). Check that electrical connections

of lights and motor (17) are correct.

FICHE D'INSTALLATION

Distance minimale par rapport à la cuisinière : 65 cm (cuisinière électrique), 75 cm

(cuisinière à gaz, mazout ou charbon). Pour le montage, suivez la numérotation

.....). Le tuyau d'évacuation et les colliers de fixation (18) ne sont pas fournis

avec l'appareil et doivent être achetés à part. Ne branchez pas l'appareil tant que

l'installation n'est pas terminée. La fiche de la hotte doit être branchée dans une prise

conforme aux normes en vigueur, placée dans un endroit accessible. Si la hotte est

dépourvue de fiches (branchement direct sur le réseau), appliquez un interrupteur

bipolaire conforme aux normes ayant une ouverture minimale de 3 mm entre les contacts

(accessible). Contrôlez que le branchement électrique de l'éclairage et du moteur (17) ont

été effectués correctement.

INSTALLATIEKAART

Minimumafstand tot het kooktoestel: 65 cm (elektrische kooktoestellen), 75 cm

(kooktoestellen op gas, olie of kolen). Voor de montage volg de nummering (1

.....).

De afvoerleiding en de bevestigingsbandjes (18) worden niet bijgeleverd en dienen

aangeschaft te worden. Geef het apparaat geen stroom totdat de installatie geheel

voltooid is. De stekker van de kap moet op een goed toegankelijk stopcontact

aangesloten worden dat aan de geldende veiligheidsvoorschriften voldoet. In het geval

dat de kap geen stekker heeft (directe aansluiting op het elektriciteitsnet) dient u een

tweepolige schakelaar te gebruiken met een afstand tussen de contacten van minstens

3 mm, die aan de geldende voorschriften voldoet). Verzeker u ervan dat de verlichting en

de motor correct aangesloten zijn (17).

75182a.fm5 Page 1 Wednesday, November 22, 2000 12:23 PM



5019 100 75182/A

AKR 931

FICHA DE INSTALACIÓN

Distancia mínima de los quemadores: 65 cm (quemadores eléctricos), 75 cm

(quemadores de gas, gasóleo o carbón). Para el montaje, siga la numeración

.....). El tubo de descarga y las abrazaderas de fijación (18) no se vienen con la

campana y se deben comprar aparte. No se debe enchufar el aparato hasta que su

instalación no esté terminada. Si el aparato está provisto de clavija, enchúfelo en una

toma de corriente conforme a las normas vigentes que esté colocada en una zona

accesible. Si el aparato viene sin clavija porque se debe conectar directamente a la red

hay que instalar en un punto accesible un interruptor bipolar conforme a las normas

vigentes en el que la distancia entre contactos abiertos no sea inferior a 3 mm.

Compruebe si las luces y el motor están bien conectados (17).

FICHA DE INSTALAÇÃO

Distância mínima dos fogões: 65 cm (fogões eléctricos), 75 cm (fogões a gás, óleo ou

carbono). Para a montagem siga a numeração (1

.....). O tubo de descarga e as

tiras de fixação (18) não são fornecidos com o aparelho pelo que devem ser adquiridos.

Não ligue o aparelho à corrente eléctrica até a instalação estar concluída. A ficha eléctrica

do exaustor deve estar ligada a uma tomada em conformidade com as normas em vigor,

e colocada num sítio acessível. Se o exaustor não estiver equipado com uma ficha

(ligação directa com a rede eléctrica) aplique um interruptor bipolar segundo as normas

com uma distância dos contactos à abertura não inferior a 3 mm (acessível). Controle se

a ligação eléctrica das luzes e do motor está feita correctamente (17).

SCHEDA INSTALLAZIONE

Distanza minima dai fuochi: 65 cm (fuochi elettrici), 75 cm (fuochi a gas, gasolio o

carbone). Per il montaggio seguire la numerazione (1

.....). Il tubo di scarico e le

fascette di fissaggio (18) non sono fornite e vanno acquistate. Non dare corrente

all’apparecchio finché l’installazione non è totalmente completata. La spina elettrica della

cappa deve essere allacciata ad una presa conforme alle norme vigenti posta in zona

accessibile. Se la cappa è sprovvista di spina (collegamento diretto alla rete) applicare un

interruttore bipolare a norme con una distanza dei contatti in apertura non inferiore a

3 mm (accessibile). Controllare il corretto collegamento elettrico di luci e motore (17).

ùüùü+ùùùþ

ü$12.)12.1.)2"0120" FP02 !"0120" FP0120".0! #

02!0. #0! # +.22  21.  #1202.!1



.....

1&.". .&".2. !.120!&1"/0/.202.0

2 . !! 32!..!0. . 2 *$&!12 2! 3 / 2020002!)

!0*.21#10#!2  !&12"0.212.1" 02!)3"2 #

. !! 32!.!0.1#/0010!.102 #1$* 2 ". 1 *

2  0210! 101 10 ü . !! 32!."/0/.203"

.0#0."1*/0102 /2# 2  02120./ )/.)2102&

. 1+00$12  .02.*2&0.3+ PP 10! 101 10 

ü2021&1202!1*/013&212+. 2!

75182a.fm5 Page 2 Wednesday, November 22, 2000 12:23 PM



AKR 931

5019 100 75182/A

Nur in der Umluftversion

For Filter Version only

Uniquement pour la Version

filtrante

Uitsluitend voor de filterversie

Sólo para el modelo filtrador

Apenas para Versão filtrante

Solo per Versione filtrante

) .  2  . .!!)31"

75182a.fm5 Page 3 Wednesday, November 22, 2000 12:23 PM



5019 100 75182/A

AKR 931 PRODUCT SHEET

Control panel

Light ON/OFF switch.

Extraction and minimum extraction speed

selection ON/OFF switch.

Medium extraction speed selection

switch.

Maximum extraction speed selection

switch.

Grease filters

Halogen bulbs

Flues

Air vent (for Filter Version)

Cleaning the grease filter

Wash the grease filter at least once a month.

Unplug the appliance or disconnect the mains

power supply.

Remove the grease filters -

Fig. 1

: pull the

spring release handle downwards, then

remove the filter.

After cleaning the grease filter refit in reverse

order, making sure the entire extraction

surface is covered.

Carbon filter Fitting and Maintenance

Fitting the carbon filter:

Unplug the appliance or disconnect the mains

power supply.

Remove the grease filter

(f - Fig. 1)

Remove the screw and then the filter holder

(g - Fig. 2)

Fit the carbon filter

(i - Fig. 2)

in the filter

holder

(h - Fig. 2)

Refit the filter holder

(j - Fig. 2)

and secure it

to the hood with the screw

(g - Fig. 2)

Refit the grease filter.

Carbon filter maintenance:

Unlike traditional carbon filters, this carbon filter

can be washed and reactivated.

With normal hood use, the filter should be

cleaned once a month. The filter is best washed

in a dishwasher at the highest temperature

possible, using a normal dishwasher detergent.

To avoid particles of food or dirt settling on the

filter during washing and giving rise to unpleasant

smells, it is advisable to wash the filter on its own.

After washing, dry the filter in the oven at 100° C

for 10 minutes to reactivate it.

The filter will retain its odour-absorbing capacity

for three years, after which it will have to be

replaced.

Replacing bulbs - Fig. 3

Unplug the appliance or disconnect the mains

power supply.

Using a screwdriver or any other suitable tool,

prise off the lamp cover.

Remove the burnt-out bulb.

Replace using 20W max halogen bulbs only,

making sure not to touch them with your

hands.

Replace the lamp cover so that it clicks into

position.

Fig. 1

Fig. 2

Fig. 3

F NL E PGBD GRI

75182a.fm5 Page 6 Wednesday, November 22, 2000 12:23 PM

Whirlpool AKR 931 AL-1 Program Chart

Marca: Whirlpool

Modelo: AKR 931 AL-1

Categoria: Exaustores

Tipo: Program Chart

Baixar PDF

relatório

Whirlpool AKR 931 AL-1 Program Chart

Whirlpool AKR 931 AL-1 Program Chart

em outras línguas

Artigos relacionados